Toho-electronics TTM000 Instrukcja Użytkownika Pobierz pdf (Strona 17)

5. Settings regarding MODBUS communications

5.1 Overview

Before communications is performed, initial settings must be made on this product. Enter such

settings with the keys on the front panel.

To switch to a series of setting screens, take the steps described below.

For details, see the operation manual furnished with this product.

For MODBUS (RTU) For MODBUS (ASCII)

Power ON

↓ ↓

Initial setting (for 4 seconds)

↓ ↓

Operation mode

↓ MODE key at least 2 seconds ↓ MODE key at least 2 seconds

Setting mode selection screen

↓ ▲▼key ↓ ▲▼key

Communications setting mode

↓ MODE key ↓ MODE key

Set a communications protocol

: MODBUS (RTU) (Initial value: )

Set a communications protocol

: MODBUS (ASCII) (Initial value: )

↓ MODE key ↓ MODE key

Set a communications parameter

↓ MODE key ↓ MODE key

Set a communications speed

↓ MODE key ↓ MODE key

Set a communications address

↓ MODE key ↓ MODE key

Set a communications response delay

↓ MODE key ↓ MODE key

Set communication mode changeover

*The changeover setting is disabled.

Set communication mode changeover

*The changeover setting is disabled.

↓ MODE key ↓ MODE key

Back to communications setting mode Back to communications setting mode

When the settings are over, press the MODE key at least 2 seconds to go back to the operation mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Brak uwag

Toho-electronics TTM000 Instrukcja Użytkownika Strona 17